Hello, this topic is to notify everybody that there is an issue with the curve creation tool that has been immediately addressed by the team.
For now, please make sure to use Degree 3 when creating and editing a curve. Using a different Degree will cause issues with the points and the editing.
Rhino uses Degree 3 as default, but to make sure you are using Degree 3 curves please click on the Draw tool and check the command bar:
- Curve Degrees can only be an odd number. Degree 1 is a polygonal line, then there is 3, 5, 7, etc.
- There is a command called _ChangeDegree that will let you change the Degree of curves outside of the Draw Command
- 曲线度只能是奇数。 度1是一条折线，然后有3、5、7等。
- 有一个名为 _ChangeDegree 的命令，可让您更改曲线的度数