Page 1 of 1

Create the boundary for hole upper

Posted: Sat Jun 22, 2019 9:14 am
by Lu Vu
Hi improvement team JEVERO
I want to create the boundary on shape insole as picture
Please support me create the upper hole of model flip flop
I using right click of the boundary
Thank you

Re: Create the boundary for hole upper

Posted: Mon Jun 24, 2019 7:10 am
by albertofranco
Hi Lu Vu,
I created a similar situation as yours and I was able to quickly create the desired result. I am not real sure what is your issue. What I have is a margin on the strobel/fussbett line (similar to what I see from your images) and I simply created the boundary taking that and the back part of the strobel.

I like to create my radii first so that I can reuse them and properly put them where I want them to be. You can create them later after the boundary.

Image

If you have doubt please share with us your file so we can take a look and help you further. You can send the file to info@jeveropattern.com

Alberto

Re: Create the boundary for hole upper

Posted: Mon Jun 24, 2019 9:24 am
by Lu Vu
Hi Alberto
Thank you so much for help me.

Re: Create the boundary for hole upper

Posted: Mon Jun 24, 2019 12:17 pm
by orca
Dear Lu Vu,

hi, hope this could help you solve your issue. Remember that the lines forming the boundaries must be connected one to another in order to create the boundary, so make sure you don't have many lines overlapping or slightly moved. If that happens, first of all check if there are pieces missing!

Have a great day,

Best regards,

Federico