Creating boundary issue

In this section you should post bugs and feature you find while using Jevero in your daily job.
Post Reply
Lu Vu
Posts: 11
Joined: Fri Feb 01, 2019 9:30 am

Wed May 06, 2020 8:26 am

Hi Develop team JEVERO
We have got a file in which a boundray is unable to creat the upper slot.
Please kindly see the picture and support for us.
We tried everything we could.
(31.82 KiB) Not downloaded yet
User avatar
Posts: 83
Joined: Thu Jan 24, 2019 9:41 am
Location: Treviso

Wed May 06, 2020 11:58 am

Dear Lu Vu

hello, thank you for your post. Seems like you might have an issue with intersecting/overlapping lines. My advice is to try to redo the boudnary paying attention to the path. You could also try using the sequential boundary creation too which is with the right click on the boundary function if you're using 2020.0 version of Jevero. If you just updated to 2020.1, it has been inverted to the left click.

Please let me know if there anything else I can do,

best regards

Federico Trentin

Federico Trentin
Jevero Support Team Member - Jevero支持团队成员
Lu Vu
Posts: 11
Joined: Fri Feb 01, 2019 9:30 am

Sat May 09, 2020 2:24 am

Dear Federico Trentin!!!
Thank you for support.
I have found the cause. it's error in the line creating slot upper.
But i don't know where the fault is on that line. creating new the line it's ok
Post Reply